What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
08.06.2025 04:23

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is where the MOV conducts again, and dissipated the energy.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
An AC voltage/ current source, and an ac inductive load.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
So, the voltage could go up to 500 volts, and the fuse will not open up.
How do you confront your own family for not inviting you or leaving you out of things?
so, what happens?
One
One is “what exactly is in a ‘surge protector’ ? ”
what exactly is a ‘surge’ protector?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Semiconductor Supplier GlobalFoundries to Spend $16B to Boost US Chip Production - Investopedia
This one hit behind the barn.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–16 [ OO OLAOYE OYEBODE ]
Can ringing in the ears be a sign of spiritual awakening?
It also is a device that limits the change in current flow.
eight
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Yankees Planning To Place Luke Weaver On Injured List - MLB Trade Rumors
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
At one ohm, the resistor has a maximum of 1 watt power.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
He then asserts :
It seems Mohan does not understand the difference between a comment and an Answer.
What type of narcissist cheats more and gets pleasure out of hurting you, even if they're married?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
The third is lightning and “how it gets conducted into a home.”
(Dc diagram shown, AC is similar).
James Webb Space Telescope unveils fiery origins of a distant, hellish exoplanet - Space
I post the exact comment here.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
First Sentence:
How One Keto Trial Set Off a New War in the Nutrition World - WIRED
The MOV will conduct when the voltage exceeds 50% of line voltage.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
The bolt then partially travels down the line to your home.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–10[John johnson John Johnson ]
The other is “what does a “fuse” do?”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But it can get overloaded, and no longer works.
There are three different concepts here that are getting confused.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
nine
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
These devices are installed between the “hot” and “neutral” and protective ground.
[image of Common-mode choke]
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is 'the assistant's answer'
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
In schematic diagrams this is the symbol for a fuse:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Here is a simplified AC power diagram.
What is lightning?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Edit 2024–10.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
These are simplified answers to the original question, and does not change anything I wrote above.
He then describes the function of a fuse.
but this device (an Inductor) … impedes the rapid changes in the current.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
A fuse is a non-resetable over current circuit protector.
the problem then depends on "how fast does the fuse operate?".
A circuit breaker is similar, but is resettable.
What does a fuse do?
He then describes Rainy Season and Lightning.
a photo is worth a thousand words.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
[old diagram got deleted by accident]
Upvotes:
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Because the load is inductive, the current lags the voltage.(by a bit).
At least they know the answer if they wanted it.
but I think this circuit , shows a few more pieces.
This device then solves the entire problem.
But… the neutral is now “floating” because of the 1 ohm resistance.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are two important concepts here.
Now when you have a certain ac resistance, then a current flows in a loop.
For this case there are devices called Metal oxide varistors (MOV).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Barnstars:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”